| To: | tncarnut1@yahoo.com, spridgets@autox.team.net |
|---|---|
| Subject: | Re: [Spridgets] Fuel line question |
| From: | Weslake1330@aol.com |
| Date: | Sat, 7 Jun 2008 16:13:24 EDT |
Are these taper thread fittings - NPT or NPTF? In a message dated 07/06/2008 20:49:37 GMT Daylight Time, tncarnut1@yahoo.com writes: This adjustable regulator has three different sizes of fittings (for use with different fuel line diameters) that screw into the regulator on either side. What should I use to seal the fittings? _______________________________________________ Support Team.Net http://www.team.net/donate.html http://www.team.net/archive http://autox.team.net/mailman/listinfo/spridgets |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Spridgets] Fuel line question, David Booker |
|---|---|
| Next by Date: | [Spridgets] New email address - No LBC, Kent Spridget |
| Previous by Thread: | [Spridgets] Fuel line question, David Booker |
| Next by Thread: | Re: [Spridgets] Fuel line question, Ron Soave |
| Indexes: | [Date] [Thread] [Top] [All Lists] |