Re: [Spridgets] Tie Rod End removal?

["Chris King" <cbking@alum.rpi.edu>]

One thing that always helps me out is to have the suspension somewhere
near ride height. There's less strain on the TRE joint than when it's at
full droop. Just put a jack under the fulcrum pin and raise it up a bit.
 
Hope this helps.
 
-=Chris

Chris King
http://home.comcast.net/~kvcbk/ 

 <-----Original Message----->

                 From: Dave G. [dmg@bossig.com]
Sent: 5/10/2008 10:34:53 PM
To: spridgets@autox.team.net
Cc: spridgets@autox.team.net
Subject: Re: [Spridgets] Tie Rod End removal? 

Like Frank says... 
But I've held a hammer to one side and hit it with another hammer hard
on 
the other side... 
It helps if you have a lovely assistant to hold a pry bar between the
rod and 
the arm... 
It helps you... not the tie-rod... 

On 10 May 2008 at 22:30, Frank Clarici wrote: 
>> I have heard 
>> but never tried the smack both sides of the arm with 2 hammers at the
>> same time. This shocks the arm enough to release the tie rod end. 

--
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets