>I had some trouble getting the new cruise control to hold speed above
>50mph,
> so I searched the web for answers.
> If you have one of these and its working great, ignore this. This refers
> only
> to an Audiovox CCS100 cruise control in a Spridget.
> Set the PPM for 8000, set it for ECM, high sensitivity and don't bother
> with
> the magnet sensor or VSS wire. Run it "tach only".
> Without the magnet, its gets all it needs to know from the coil. You can
> just
> cut off the fat gray wire.
Ya know, I almost emailed you when you posted about hooking up the magnet,
but you sounded as if was working for you. That is the same result I had
with mine. The only conclusion I was able to come up with was that it
figured that the rpm of the driveshaft with a 3.9 and 13" tires represented
too great of a speed. Like you, I researched and called AudioCVox's tech
support to no avail. As soon as I set the switch for tach signal only, I was
good to go.
David Lieb
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|