spridgets
[Top] [All Lists]

Re: [Spridgets] Bugeye Group..... Re: A series head ??

To: Lester <oldsaabguy@comcast.net>, bugeye@yahoogroups.com
Subject: Re: [Spridgets] Bugeye Group..... Re: A series head ??
From: <uniquelittlecars@yahoo.com>
Date: Sun, 13 Jan 2008 13:20:38 -0800 (PST)
I figured i would just leave the plug in and try it. I looked in vizard - But i 
do not think he covers this or i missed it. The book is kind of a over welming 
read. Some of the stuff is beyond me. In the past i would send a motor off to 
builder. This time around i think i am going to give it a go. I have two blocks 
. 1275cc? and a 948cc? I know nothing about either motor. 
   
  vigil
Lester <oldsaabguy@comcast.net> wrote:
  I turned the head upside down, and used a pipette to run in a volume 
of water until the chamber is full. Not perfect I know as you are 
supposed to place some plexi or glass on the cylinder head to give the 
water a place to stop. But it's close enough..

Lester

On Jan 13, 2008, at 11:07 AM, > wrote:

> New Question - I found a head in the back of my garage. i know from 
> the casting it is from a 948cc "A" Motor from a Morris vehicle. Ok - 
> Here is my question. Is there a chart or a formula to figure the CC 
> of the head? The head is not on a motor. I have got a ruff figure on 
> another head by using liquid. Then cranked the motor with and old 
> towel over the head to catch the fluid. I was only gas so i could 
> have just fired the motor. I figured it may cause problem so i used 
> the towel method. I am assuming you take a flat and messure to the 
> bottom. How do you figure in the curves or round edges to get your 
> number.
>
> Vigil
> "Robert E. Shlafer" 
wrote: Stock Spridget 
> 1275's were 21.4cc's.
>
> Cap'n. Bob '60 :{)
>
> -----Original Message-----
> From: Lester
> Sent: Saturday, January 12, 2008 10:13 PM
> To: bugeye@yahoogroups.com, Spridgets net
> Subject: [Spridgets] A series head ??
>
> Ok, so what is the size of the combustion chamber? I measured 22cc's
> on the one I have. anyone know if it is stock or has it been massaged?
>
> Thanks,
>
> Lester
You are subscribed as uniquelittlecars@yahoo.com

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets


       
---------------------------------
Never miss a thing.   Make Yahoo your homepage.
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>