New Question - I found a head in the back of my garage. i know from the casting
it is from a 948cc "A" Motor from a Morris vehicle. Ok - Here is my question.
Is there a chart or a formula to figure the CC of the head? The head is not on
a motor. I have got a ruff figure on another head by using liquid. Then cranked
the motor with and old towel over the head to catch the fluid. I was only gas
so i could have just fired the motor. I figured it may cause problem so i used
the towel method. I am assuming you take a flat and messure to the bottom. How
do you figure in the curves or round edges to get your number.
Vigil
"Robert E. Shlafer" <pilotrob@webtv.net> wrote: Stock Spridget 1275's were
21.4cc's.
Cap'n. Bob '60 :{)
-----Original Message-----
From: Lester
Sent: Saturday, January 12, 2008 10:13 PM
To: bugeye@yahoogroups.com, Spridgets net
Subject: [Spridgets] A series head ??
Ok, so what is the size of the combustion chamber? I measured 22cc's
on the one I have. anyone know if it is stock or has it been massaged?
Thanks,
Lester
You are subscribed as pilotrob@webtv.net
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
You are subscribed as uniquelittlecars@yahoo.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
---------------------------------
Never miss a thing. Make Yahoo your homepage.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|