IIRC Bob C, you are in the KC area??
<<I ordered the bearing and bushing etc to rebuild my gererator.AS I recall,
the plate that secured the ball bearing in place was held in place by
rivets.Is there room in there for small machine screws, or will I have to
try to
rivet it in? >>
Yes there is for EXPERIENCED folks. "Try to..."??
I do not recommend you do it. Surely, within the entire two major cities
there is a generator re-builder or two??
Might cost ya $10 - $20. Too "expensive"??
Ed
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|