Hello all,----any advice on how to install the extra grease fitting on the
lower wishbone spring plate? Drill and tap threads,----just drill a hole and
force it in? What stays put? I have a grease gun with a rubber tip so maybe
just drill a small hole and pump it in? Maybe use a small cut down bolt to
screw in to close hole? Any thoughts out there? I am wondering if the pressure
would blow out the grease fitting. Bob C
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|