Dave,
I used some kind of Painless Wiring fuse block in FROG AYE. I think it's
about 12 circuits. WAY overkill. But now I got separate circuits for
everything and a relay for the horn, and,.... Oh, yeah, a home made wiring
harness that I'll finish someday.
Too much work. Don't think I'd do it again....
Hal
-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
Dave G.
Sent: Tuesday, August 14, 2007 2:13 PM
To: spridgets@autox.team.net
Subject: [Spridgets] Wiring Harness...
The wiring on my beast is totally screwed-up! I'm considering re-wiring it
from the ground (no pun intended) up.
It is still a positive ground system.
Has anyone used the "Painless Wiring" 8 Circuit Modular T-Bucket Harness,
Part No. 10308 to re-wire a Spridget?? Specifically a '65-67 Mk III...
If so, was it a good or bad expeience??
Do you think it was an easier to install than the purpose-built
Vic-Brit/Moss
harnesses??
Suggestions welcome
TIA
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|