I bought a set of four from Jegs (www.jegs.com). Look like regular
sockets but have a cam mechanism inside. I tried one of the
one-size-fits-all big cam tools from HF, but it wouldn't release very
easily and it eventually broke. I was using the double-nut method until
I bought the Jegs set, which is OK if you only build one engine every ten
years.
David
On Wed, 8 Aug 2007 11:21:36 -0700 (PDT) rrengineer@dslextreme.com writes:
> Another head stud question. Any of you guys use stud sockets of any
> type
> to install your studs? If so, where to buy and what cost? The
> same
> engine builder friend of mine suggested cheap head stud sockets that
> work
> with washers somehow. He said you could get a cheap Chinky setup
> and just
> throw them out after using them. Horrible Fright Have these?
> Mike MacLean
> 60 Sprite
> 56 BN2
> _______________________________________________
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|