Hi Charlie,
I built one out of some junk angle iron and pipe I had kicking around.
2"angle for the bed, 1 1/2" angle for the bracing and 2" pipe for the legs.
I had an old Datsun radiator with a fan attached that I used for cooling,
switch for on, and some bent strap for the muffler to set on.
I've used it for all the "A" series engines, mini included and now ready to
run some Datsun ones on it. Have an electric fuel pump and toggle for it
and spark. Solenoid for the starter, ancient Morris Minor motor towers.
Lot easier to use than Spridget ones. I cut the legs at an angle on the
bottom and welded large caster wheels from Harbor freight. 2 fixed, 2
swivel.
An assortment of rad. hoses allows me to hook up about any engine. A tip
for the muffler setup. I use the engine exhaust pipe with an adapter or 2
from the auto parts store and I just slip them into each other and to the
muffler I have for this getup and use sheet metal screws to keep them
together. One per joint is all that's needed
Oil pressure guage with a temp guage from the radiator works out nicely. I
use a dummy transmission, case only, for the rear supports. Whole thing is
about 6 feet plus long
My only regret is I didn't do this 20 years ago.
Later, Paul A
----- Original Message -----
From: "charlie shelden" <shelden3@pldi.net>
To: <spridgets@autox.team.net>
Sent: Wednesday, April 18, 2007 8:49 AM
Subject: engine test stand
> I have several 1275 motors 1098 and a 948 that I'd like to test out. One
> will hopefully be going into my Bugeye soon. When David O. gave me the
> motors he said one was recently rebuilt (1275's)but wasn't sure which at
> the time. I thought it would be good to build a test stand. Has anyone
> done this? Can I do it out of lumber or is that just foolish? I can weld
> just fine, but don't have any metal and am trying to do it the "we tight"
> way. I figure I'll need a muffler which I have, as well as a simple panel
> for a aftermarket tach and oil preasure gauge. For one engine I think it
> would be much trouble but I have 3.
>
> Any opinions or expertise is much appreciated, designs you used even
better.
>
> Charlie
> 59 Bugeye project
> OKC,OK
|