Here is the fix. Turn the Fulcrum around, thread the large end in first, this
is were the prob is. Use a half inch open end wrench on the center intent
thingee for purchase, oil well and keep working Fulcrum in and out till the
large end is into the center of the wishbone several turns.
Now clean all very good and assemble properly.
As you note the prob is that the threads do not go all the way through the
large part of the wishbone, the Fulcrum is hard enough and has a slot in it so
works preaty well as a tap. The Fulcrum is also such hardned steel that the
open end wrench will not harm it at all.
|