Billy
Had my last email that I sent to you returned. See previous post I made for
the email addy for the pics of the car and see what you think of the body.
Text of the message that was returned is as follows:
Here's a pic of the whole left side of the car. 1/4 is available to you if you
want it, will need shipping costs. I know the bottom of the 1/4 behind the
wheel is loose from the rest of the structure. Can get sawzall to cut it off,
will need to get specific instructions on where to cut. I don't want to seem
dense but I can send as much or little as you want, I want to get it right,
will only have one shot at it. Some specific details I need: OK, you need the
section where the door striker screws to the body, so the rear part of the
door jamb. Do you need any of the inner structure, like inside of the lip the
weatherstrip attaches to? I understand you want the "bead" on top of the 1/4,
I assume cut just inside the bead. Unsure what to do as the cut approached the
very rear of the seam, near where the tail light attaches. Or should I just
make a cut across the left side of the rear scuttle so you have the entire
left side of the trunk opening? I know i will have to figure out how to get
the 1/4 seperated from the rear bulkhead and wheel arch. You need how much at
the rear, not making sense of the "bumper bracket", you mean where the holes
are in the rear that the bumper brackets bolt to the body? Dan
|