I have always had good luck with Zales or Robbins 8th and Walnut.
Larry
On Nov 2, 2006, at 14:52 PM, Glen Byrns wrote:
> I just got off the phone to the order desk lady at Deves Rings. If
> you like
> or use Deves rings for your LBC pistons, bad news. Apparently the
> company has
> or will be sold and isn't taking or filling special orders.
> I had Deves rings on the custom Venolia pistons I am running in the
> turbo
> Sprite. I shattered two compression rings when a blown head gasket
> dumped
> water over the front two pistons and the high torque gear-reduction
> starter
> had enough oomph to shatter the rings as it tried to compress the
> water in the
> cylinder on re-start. Bummer.
>
> Does anyone have a preferred ring supplier? Total Seal, Grant's ?????
>
> Thanks,
> Glen Byrns
--
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|