I'm reassembling a 1275, and I thought I had purchased
every gasket possible, plus some, for this engine. As
I dug through stuff yesterday in preparation for
putting the pan on, I found gaskets that were close,
but not right. I ordered a lot of stuff from
MiniMania, so now I'm wondering if the pan is
different on the transverse mount 1275? I'll go
through all my stuff again tonight, but If I can't
find the right ones, what's the current wisdom on
trying to cut your own?
Thanks,
Joe Lansing
62 Sprite
Tired of spam? Yahoo! Mail has the best spam protection around
|