Thanks you guys. I must be lucky today because I got it in tapping it on
the vise anvil and didn't bend the pin. It looks good and no slop. Why
are the shaft bushes $70? I'm glad I didn't need one.
Now I have the base plate in hand and there is no fork to hold the terminal?
Must be the wrong one. I have another so I can use that one. I see the
base plates are NLA at Mo$$.
Hopefully I'll have time to put it in today and test it.
Phil Nase
http://home.comcast.net/~philnasecpa
Phil Nase wrote:
> Any tips on, how to, or not to, drive the pin back in the drive dog
Phil
The shaft is drilled for a one way only pin fitment.
If you try it 180 out, you can do it but now you bent the pin.
Stick the drive on and look thru the hole, make sure it is on the right way.
It's close when it's 180 out but close only counts in horse shoes and
bottchi ball ;) Also different drives will not fit different dizzys. Each
was drilled as a unit.
--
Frank Clarici
Toms River, NJ
|