Hi List,
Before I swap the clutch slave cylinder on my Spridget I plan to lose all the
'lost motion' in the linkages. I changed the clevis pins on the slave and
master some time ago. This evening I've swapped the master cylinder push rod
since the old one was about 18 years old and the clevis pin hole was slightly
oval.
I do have a spare clutch pedal which I had the clevis pin welded up at my
local friendly but now greedy garage (#5) but I've began to botch drilling the
hole (I lack a drill press/pillar drill) and snapped a lot of bits.
So, is anyone on the list an expert at doing this and wants to do another or
know of a source of NOS clutch pedals?
Regards
Daniel1312
|