Thanks Bud,
Yes "Safety First" is what I tell all my students, I teach technology
education engineering design, it was Industrial Arts years ago. I won't let
kids bring in any foam because of the carcinogen factor. We model make
products with hot wire design tools and hard foam from our school supply
company but even that is a little risky. I like the plastic wrap overnight
idea. I'm going to try the old wire brush method on the drill first, yes
with protective eye ware and such. Ether way it will be a mess. I don't know
what people are thinking by gluing in furniture foam on the floors.
Thanks again,
Linda
62 Sprite
On 5/23/06, Bud Osbourne <abcoz@hky.com> wrote:
>
> Linda,
> I'd stay away from the torch. No telling what type of fumes that stuff
> will produce, when heated. No matter what, there's no quick & easy (not
> to mention clean) way of doing it. If it were me (and, I thank God that
> it isn't ;) ), I'd get anything "loose" off with a wire
> brush/scraper/wire wheel. Then, I'd apply a good paint stripper (I use
> Tal-Strip, by Mar-Hyde), and remove the resulting gooey mess with a
> putty knife. Oh, yeah, you'll want to remove seats, carpets & trim
> panels, 'cause what the paint stripper will do to them is NOT pretty.
> Obviously, safety goggles & the appropriate rubber gloves are a MUST,
> along with adequate ventilation.
> BTW, I've found that I get a lot more "mileage" out of the stripper by
> covering it with Glad Wrap, or some other plastic wrap, after I've
> brushed it on. This seems to keep the stuff from drying out, and allows
> me to leave it overnight, allowing full penetration, and keeping the
> coating from re-setting, as the solvent evaporates (which it can't do,
> when covered with the plastic wrap). For some reason, the stripper (at
> least, Tal-Strip) does not attack the plastic wrap.
> Have fun, and be careful.
> Bud Osbourne
>
> -----Original Message-----
> From: owner-spridgets@autox.team.net
> [mailto:owner-spridgets@autox.team.net] On Behalf Of Linda Grunthaner
> Sent: Tuesday, May 23, 2006 5:59 AM
> To: spridgets@autox.team.net
> Subject: removing glued foam
>
> My 62 Sprite appears to have glued in foam on the floors does anyone
> have
> ideas on removal? And yes I'm looking for a fast easy method. I was
> thinking
> of torching it off but that would lead to a gooey mess, then thought of
> a
> solvent but that too would lead to a gooey mess. I could just scrape and
> wire brush but was thinking there may be some new solvent I was unaware
> of
> that I can apply which would dry it up so I can easily wire and scrape
> off.
> Thanks Linda
>
> 62 Sprite
|