Spridgeteers,
Finally am getting the Midget back together and have a couple of
questions for ya'll.
1) Once I installed the new back plate, resurfaced flywheel and new
clutch, I put three bolts back to pull the tranny up and then went to
test to make sure the clutch is working. I can't move the pressure
plate spring with hand pressure on the yoke. How hard should this be?
I didn't want to force anything, but I do want to be sure that the
damned thing works before I put it all back in. How much force should
it take to depress the pressure plate spring?
2) tranny pilot shaft splines... Grease them?? If so what kinda
grease and how much?
3) Who's coming over to Dodge City this weekend to help me put the
lump back in? Where's the OSHIT or SOS High Plains chapters when you
need them? ;-)
Cheers!!
Jim - finishing Midget in Dodge City
--
1964 R60/2 BMW
1968 MG Midget
1976 R90/6 BMW
1990 K100LT BMW
**In democracy your vote counts. In feudalism, your count votes**
|