It's the cast hole for..... call it equalizing.... pressures, liquids,
fingers etc. One side is smooth because the face is machined after the
block is cast.
Regards, Bill
Joe Lansing wrote:
When I removed the
timing gear and chain I found a hole that passes
completely through the block, from the smooth machined
side behind the chain to the inside. I've taken a picture available at
http://server5.pictiger.com/img/95729/cars-and-motors/block.jpg.
Is this normal and functional, or do I have a flawed
or damaged block?
Thanks,
Joe Lansing
62 Sprite.
Your messages not reaching the list?
Check out http://www.team.net/posting.html
=== Help keep Team.Net on the air
=== http://www.team.net/donate.html
=== unsubscribe/change address requests to majordomo@autox.team.net or try
=== http://www.team.net/cgi-bin/majorcool
=== Other lists available at
=== http://www.team.net/mailman/listinfo
=== Archives at http://www.team.net/archive
=== http://www.team.net/the-local
=== Edit your replies!
|
