Good thought - I do have access to a Rockwell hardness
checker. I could check stud hardness, then choose
material. Being a Boss Mustang guy, try not to laugh
- these are Spridget 3/8 studs torqued to 40 ft-lbs (I
may go up to 7/16 finally). FYI - while I admit to run
a die over a wheel stud in a pinch, I think the
threads are rolled and really shouldn't be cut in any
way. But then again, you big-bore guys use impact
wrenches to adjust your points, so you've got more
margin than we Spridget guys do.
--- Bill Dalton <bill@daltonstudios.com> wrote:
> I would suggest something that is softer than the
> studs so that the lug nuts
> would deform first. On the Ford Mustang the threads
> are 1/2-20UNF. I used to
> torque mine to 110 ft-lbs which is the max for
> unlubricated thread and I
> would find that every winter I had to re-tap the
> nuts and I would run the
> die down the studs. I backed off 5 ft-lbs at a time
> until I found at 95
> ft-lbs I didn't have to do either. These lugnuts are
> the stock appearing
> deep acorn nuts available at good parts stores. At
> about 100 ft-lbs I didn't
> have to run the die down the studs, but above that I
> threw away about 5 of
> the 20 every winter, but never had to replace a
> stud. They were definitely a
> tougher, higher strength material than the nuts. I
> would use the 4140 unless
> it is harder than your studs.
>
> Bill
Tired of spam? Yahoo! Mail has the best spam protection around
Your messages not reaching the list?
Check out http://www.team.net/posting.html
=== Help keep Team.Net on the air
=== http://www.team.net/donate.html
=== unsubscribe/change address requests to majordomo@autox.team.net or try
=== http://www.team.net/cgi-bin/majorcool
=== Other lists available at
=== http://www.team.net/mailman/listinfo
=== Archives at http://www.team.net/archive
=== http://www.team.net/the-local
=== Edit your replies!
|