I have a bit of a problem with my drivers side door ('75 Midget).
The door would lock on its own about every other time you closed the door.
I took off the door panel to see what was wrong, and as far as I can tell
the door lock do-jigger does not seem to have enough travel. I did not have
too much time, so had to put the panel back on. When I tightened down the
door handle/lock mechanism, I cannot move the little door lock lever. I am
thinking the lock/latch mechanism inside the door is too far toward the
inside of the car so that tightening down the inside door handle/lock
mechanism binds the little lever. Could the PO have put the piece inside
the door in wrong?
Any thoughts before I attack it again?
Bob
'75 Midget
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.10 - Release Date: 2005.05.13
|