I'm ready to dremel a Bugeye tach can to fit an electric tach. Before I do
that I need advice on the tach electrical connection please.
There are 3 connectors on the tach. Two that look like bullet connectors
(one male and one female. The other is a spade terminal. My wiring diagram
show a white wire from the ignition switch, a white wire from the coil and a
green wire from the fuse box. Does this sound correct and what connector
gets what wire?
Any tips or tricks on the conversion are also appreciated. Thanks everyone.
Phil Nase
http://home.ptd.net/~nase
|