When I tighten the trunnion all the way down on the kingpin with no shims I
have too much clearance between the trunnion and the thrust washer. If I
were to reduce the thickness of the thrust washer the clearance would
increase. A thicker (new?) thrust washer would allow me to add shims to
obtain the proper clearance.
Rick
----- Original Message -----
From <Daniel1312 at aol.com>
To: <refisk@chartermi.net>; <spridgets@autox.team.net>
Sent: Thursday, April 21, 2005 5:22 PM
Subject: Re: Kingpin clearance
> My brain is not in gear but I think if you file or sand the thrust washer
> you
> then get to the point were you can start using shims or is my brain really
> not in gear?
>
> Daniel1312
>
> In a message dated 21/04/05 03:03:37 GMT Daylight Time,
> refisk@chartermi.net
> writes:
>
>> Does anyone know if
>> replacement thrust washers are available?
|