I don't have my Machinery's handbook at home with me, but I believe NPT
threads come both tapered and non-tapered. I'll double-check tomorrow.
Chris
<-----Original Message----->
From: Larry & Sandi Miller
Sent: 4/7/2005 5:23:39 PM
To:
pasgeirsson@worldnet.att.net;cbking@alum.rpi.edu;spridgets@autox.team.ne
t
Subject: Re: Another Thread For Jay
According to others you are correct, BSP is not tappered.
----- Original Message -----
From "Paul Asgeirsson"
To: "Chris King" ; ;
Sent: Thursday, April 07, 2005 2:08 PM
Subject: Re: Another Thread For Jay
> But I think the BSP isn't tapered. Might be wrong!
>
> Pa
>
> ----- Original Message -----
> From: "Chris King"
> To: ;
> Sent: Thursday, April 07, 2005 1:15 PM
> Subject: Re: Another Thread For Jay
>
>
>> Machinery's handbook says possibly. 1/2 NPT is 14 threads per inch,
1/2
>> BSP is also 14 thrads per inch.
>>
>> Chris
>>
>> <-----Original Message----->
>>
>> From: Larry & Sandi Miller
>> Sent: 4/4/2005 7:34:20 PM
>> To: spridgets@autox.team.net
>> Subject: Another Thread For Jay
>>
>> When looking at hoses and oil coolers are 1/2" NPT and 1/2" BSP
>> compatible?
.
|