I need to remove the wings from the bonnet. It appears that the wings ,
fender bead, and bonnet are spot welded together. Needless to say, there is
not
enough room to use a spot weld drill bit and drill to remove the welds.
Are there any alternatives that anyone has used with success?
I was thinking about trying to fit a abrasive cut-off wheel between the
fender flange and bonnet bonnet to cut through the fender bead and spot-weld.
Thanks for any any suggestions.
Gary Bouffard
59 Bugeye (aka garage clutter)
59 TR3A (restored)
|