I have been using never seize for years. They come off, they go on.
Also if they leak just the tiniest bit. Well heck, it's silver, who
cares.
Larry
On Nov 17, 2004, at 3:55 PM, john.dagostino@comcast.net wrote:
> I have been wondering the same thing. I spent a couple of hours
> cleaning 30 years of hardened grease from the hubs and spinners. So
> far I haven't put anything on them. I was wondering if antiseize
> might be good to use?
>
> j
>
> -------------- Original message --------------
>
>
>> What's recommended as a lubricant for wire wheel hubs? What about the
>>
>
>
--
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question
and you're a fool for the rest of your life.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
MailScanner thanks transtec Computers for their support.
|