I am trying to rebuild a dual circuit master cylinder. I got out that nylon
washer, and both circlips, and the washer underneath the last clip. How in
the world do you get the piston out? I tried pulling, I tried compressed air
and the piston is still in the bore. I looked in the shop manual and I don't
think I have missed anything. Do I just need to eat my Wheaties and pull
harder?
_______________________
Bill Gilroy
77 MG Midget
"life's journey is not to arrive at the grave safely in a well preserved body,
but rather to skid in sideways, totally worn out, shouting " holy sh*t...what
a ride!"
|