I have the bulb holder itself. What I don't have it the metal piece that
it clips into. I guess that's why the PO duct taped it. The plastic lens
piece appears original as that is what the dash bezel screws into. It
appears that the metal piece, whatever that looks like is missing. I was
planning to just run a ground wire but was thinking if I can procure or
make an original type piece it would make it easier to mount.
I don't really want to re-duct tape it :)
Herby
64 MKII Sprite (Herbytoy - patiently waiting)
62 MKII Sprite (the "resto-mod" driver)
billh@aaai.com
http://www.herbytoys.com
-----Original Message-----
From gerard [mailto:pixelsmith at gerardsgarage.com]
Sent: Thursday, July 08, 2004 11:14 AM
To: Bill Hunt
Cc: spridgets@autox.team.net
Subject: Re: Signal indicator
Bill,
As I recall, the bulb holder is a spring loaded (tangs around the
perimeter) press fit into the metal bezel. But that should be obvious
to you if that's what you have. Maybe the bulb holder was changed.
You could always run a ground wire from the holder to ground if that
is the case.
Gerard
|