I would contact Moss about the parts that appear not to fit.
The bonnet gasket does not follow the curved area of the gutter, so the
one you have is probably the correct length.
In answer to your question about a gasket between the heater box, the
answer is yes there was. You can used any type of foam weatherstripping
of appropriate thickness to seal the area between the heater box and the
duct opening.. 1/4" should probably do it.
--
jay fishbein
wallingford, ct
http://home.ix.netcom.com/~type79/ <http://home.ix.netcom.com/%7Etype79/>
Lester Ewing wrote:
> Morning all!
>
> I have a bit of a problem here, I ordered several bits from Mo**
> and they don't seem to fit. To be specific, I have the rubber washers
> that fit under the wiper arms. They are too small. Also, there is a
> rubber bit that fits the body at the trailing edge of the bonnet but
> this piece appears to be about 1 foot too short.
>
> Lastly, is there supposed to be a gasket to some sort between the
> heater box and the body?
|