In a message dated 1/1/04 7:37:48 PM Pacific Standard Time,
rrivenbark@cfl.rr.com writes:
> For the life of me, I cannot get this damned guide bearing to come out. And
> yes, I did remove the circlip. How do you get this *%^&$@& thing out.
Tad:
Two things have worked for me--drilling a hole into it and screwing a long
thin screw into the hole to pull it out, or, preferred, I like to heat a thin
guage nail in a torch to red hot, then melt the insert in two. Don't worry
about destroying it--there is a new one in the rebuild kit. Reason I lie the
melting procedure is there is less chance of marring the inside of the cylinder
with a hot nail than there is with a drill and screw.
--David C.
|