Hi Larry, I have that setup on my Mk2 (1275) Sprite. I solved the vent
problem by tapping the fuel pump boss for a 3/4" NPT gas pipe 90 deg
street elbow and running a rubber hose upward with a Pep Boys breather
plugged in the top end. This has been on the car since 1996 and it has
worked well for me. Several folks looked it over at Sprite Rush in
1998. Some liked it and some didn't. Feel free to contact me if you'd
like more details.
Jack
-----Original Message-----
From Larry Pitts [mailto:FUZZY95687 at YAHOO.COM]
Sent: Wednesday, September 24, 2003 12:00 PM
To: spritenut@Exit109.com; spridgets@autox.team.net
Subject: crank case ventilation
Frank
If I recall from Sprite Spree you had a belt drive timing setup in your
little yellow car with the Speedwell bonnet. While reading through
Vizard about dizzy curves, he speaks very highly of the belt drive
setup, not only for timing issues but for noise and vibration. If you
could clarify for me, the engine front plate is replaced, esentially
blocking off the crank ventilation from the front cover, is the only
means of ventilation now through the fuel pump pad?. How are you
ventilating that car and how's it working for you.
Any other listers running that setup?
Larry Pitts
60 Bug
|