I've used the brake drum re-installed backwards so that it can be whacked
with a hammer as you rotate it.
Peter C
At 08:43 AM 9/11/2003, Vernon Brown wrote:
>I need to remove the rear hub from my car and do not have tool 18G 146 as
>specified in the manual. I guess I can use a bearing puller I have if I go
>to the machine shop and get them to make a "plug" for the axle so I have
>something for the puller to push against and go to the metal shop and get a
>couple pieces of angle iron cut to connect the puller to the studs. This
>sounds like a lot of running around and could get expensive. Is there a
>better way?
>
>Thanks
>Sandy Brown
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|