In a message dated 9/5/03 8:39:06 AM Pacific Daylight Time,
john.dagostino@comcast.net writes:
> My snap ring pliers can't
> get a good grip on the snap ring down in the bore. Is there a special set of
> pliers or some trick to removing it?
>
John:
I took a cheap pair of needle nose pliers to my grinder and ground the length
of them down until they were very slim and flat. Then a slight groove in the
outside of each tip and they fit right in there and squeeze the snap ring
enough to remove.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|