Hello fellow Spridgeteers,
Could someone please describe me how your rigid brake pipe is routed from
the brake master to the 4-way union on the "other" (RH) side of the engine?
In my case it's a combined brake/clutch master and the servo is on the RH
side. BUT the main pipe goes *UP* about 5 inches from the master, behind
and above the battery, (on the bulkhead with 2 p-clips), across the engine
and down to the servo. No wonder I can't seem to be able to bleed that,
tried both the eezibleed and "assistant" methods. How on earth did it work
before I had to replace the master seals, I don't know. Finally, do I have
to have the engine running to bleed the servo?
Evangelos
66 Sprite Mk3 LHD.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|