Re: Tach Conversion

Another conversion is to take a later smaller - grd tach,
remove the guts from the housing, a bit of dremel work to the larger housing
and the smaller guts will screw right in.
Swap the face plate and needle from the larger tach and you now have
a neg ground tach. This also eliniates the white wire loop as it is 
internal in the later tachs. Just cut your existing white wire and plug 
each end onto the 2 plugs on the tach. Green wire goes to the same spade.



-- 
Frank Clarici
Toms River, NJ
5 British cars on the road
http://www.exit109.com/~spritenut

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets