Hello to all:
Does anyone have the measurement of the calibration block for the
differential/bevel pinion gauge, tool # 18G191.
I know what the manual says ( nothing on the height) but just says use it
to check the back lash. It doesn't mention what the calibration block
heights are to compare it to.
Anyone ever see one in person, or have one.???
Brock
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|