In a message dated 5/17/03 11:14:33 AM Pacific Daylight Time,
pixelsmith@gerardsgarage.com writes:
<< so make sure you put the correct thick
spacing washers on the 3 bolts that attach the column up by the dash in the
same locations on reassemby. You should note the positions of all the
column hardware for that matter. >>
Just put it all back the way it came out? Like Haynes' assembly is the
reverse of disassembly? Probably good to make wax pencil marks at various
places to insure correct locations.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|