ready to weld new outer sill, I think. Im not getting ideal alignment in the
rear 1/4 panel though. I get a slight gap between the sill and the lower edge
of the 1/4 panel. Ive got 12 vise grips holding this thing on for now, and have
one clamping the sill to 1/4 panel at rear most edge by the spring box area. Is
this a typical problem? I do not see an easy way to clamp the 1/4 panel and
sill together from inside or out. I tried using hydraulic jack to "push it up"
but that resulted in pushing the car body up off the sawhorses. I imagine once
its all welded/ground it will look "good enough" but figured Id ask before I
weld it for life.
__________________________________________________________________
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|