> Get a cold chisel, one with a hex shaft, and suitable in size to fit the
> pin slot. Grind the tip to suit even better. Stick a socket or impact
> wrench on the end of the chisel handle.
> Worked for me.
Strangely enough, that's exactly what I did as well. Worked for me, too. Ed
showed me a 3/8" drive SnapOn screwdriver bit that he got machined to fit
the hole and the groove perfectly. At around $20 it might be a little more
than the chisel, but it sure looked like it might work even better.
David Lieb
RWA Midgets
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|