I used Midel when I was re-building the H1 carbs for my Bugeye. Bill had bodies
and other parts I needed in stock. This is NOS BMC stuff. You could probably
build a set of S.U. H1s from parts for less than $200 bucks from S.U. Midel. I
was very satisfied also.
Mike MacLean-60 Sprite
"ptegler@cablespeed" wrote:
> This isn't a 'hunting' request...this is a 'praise' email
> for a source that to date...has never let me down.
>
> I needed/wanted a new pair of needles for my HS4 setup.
> As usual my first point of contact was Mr SU himself, Joe Curto
> up in NY. Nope...nada... none in stock. (#'s I wanted) same too
> with the catalog all the companies.
>
> So my old standard was called Midel, in Australia. UNREAL!
> Bill had 'em in stock. And the best part.... even including airmail
> shipping, they were cheaper than any U.S. source found.
> Both needles, including airmail s/h $$ to the U.S. from Australia
> was $21.26 total for the pair.
>
> I'm usually not into pushing vendors... but if you need SU carb parts....
> Call Bill at Midel Pty. Ltd. www.midel.com
> Tell Bill I sent you :^)
>
> nfi...just a VERY satisfied customer!
>
> Paul Tegler
> ptegler@cablespeed.com
> www.teglerizer.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|