At this point, the problem appears to be the new master cylinder. When you
set the old and new side by side, the old has a piston length that is 1/2
inch longer than the new cylinder.
-----Original Message-----
From owner-spridgets at autox.team.net
[mailto:owner-spridgets@autox.team.net]On Behalf Of DLancer7676@cs.com
Sent: Sunday, March 16, 2003 11:13 PM
To: bmantz@roanoke.infi.net; spritenut@Exit109.com
Cc: spridgets@autox.team.net
Subject: Re: Still Clutch problems
In a message dated 3/16/03 5:59:36 PM Eastern Standard Time,
bmantz@roanoke.infi.net writes:
> The throwout bearing is 1/32 from the pressure plate face
> before depressing the clutch
Is the pressure plate in backwards?
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|