RE: Rear wheel bearings

Thanks Mike.  How about just roughing it up with a wire brush wheel on a
drill and then using the compound?

        -----Original Message-----
        From:   Mike Gigante [SMTP:mg@sgi.com]
        Sent:   Wednesday, March 05, 2003 11:14 AM
        To:     spridgets@autox.team.net
        Subject:        Re: Rear wheel bearings

        It is called "Retaining Compound", they make it in at least two
strengths.
        Go for the stronger stuff.

        BTW, you can get a machine shop to crosshatch the bearing seat on
the
        inside of the hub to help the sloppy fit and to get the retaining
        compound to work a little better.

        Mike

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets