Does anyone have experience with the exact sizes of 7/16" wheel studs I
need to purchase to upgrade from 3/8".
And secondly, What size do I need drill the hubs to accommodate the
splines. I'm assuming that I'm going to have to pull the rear axles and
front hubs to drill them and can anyone share any secrets on the best
way to drill them accurately?
--
Jay Shaffer
ITC #66
'76 Midget
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|