James Gruber wrote:
> Steel or Brass/Copper Fuel line
I have been using plain old copper tubing (1/4") the stuff for fridge
icemakers. Cheap, bends easy, doesn't rust.
> How long does it need to be, 5' , 6'
Comes in a 10' roll, I think I used about 8 feet.
> Any good ideas on some sort of clamps to hold the new fuel line to the frame
>rails other than drilling and tapping the frame rail for some sort of screw
>fitting.
You can buy those frame clips and the hair pin clips for the seat rail
frame reinforceing plate
at most hardware stores. I do know the hair pin clip is called "Hair pin
clip" But the clip for the pipe/frame is also available, i have seen it
but do not know the correct term. Bring an old one to the store and show
them. You might find them in the Dorman draws at the auto parts store too.
--
Frank Clarici
Toms River, NJ
2 Sprites, 2 Midgets
http://www.exit109.com/~spritenut
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|