"1 On the early steering racks, the thrust washers for the pinion,
Does the cone part of these washers face towards the gear or away from
the gear? It's a bit hard to tell from the pics in the book but it looks
like the cones point away."
PS you should shim the end float of the pinion too. good luck finding shims for
it though. Out of curiosity, is there a small square void between the last
tooth and the metal end of the actual rack? I found this on mine, and was told
its probably from the jig to cut the teeth. -Josh
__________________________________________________________________
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|