Weelllll, ... I got a great deal on this LCB header from the MG Owner's club
in England, it came with a nice exhaust sytem as well.
Only one problem...the @#%* LCB header won't clear the steering shaft!
I think that this is not an issue with RHD cars in England but it is a Big
deal here!
I have attempted to reshape the center pipe (with a BIG hammer) but it seems
like I am going to have to pound it too flat and it will be constricted at
that point.
If I could bend the entire header a little closer to the engine...
But I can't figure out how to bend it smoothly at the flages. When I try
pushing it hard towards the engine, the rubber motor mounts absorb all the
push.
At this point, I am out of ideas and it is looking like I am going to have
to eat this header and buy one from who? APT?
Any ideas appreciated...
Bill
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|