In a message dated 1/24/03 8:35:59 PM Eastern Standard Time,
wolfbj@prodigy.net writes:
> I have tried standard JB Weld on an exhaust manifold crack
I bought a $3.69 tub of old time stove cement and repaired a significant
crack in my manifold. I first kneaded the stuff till it was clay-like, then
forced it into and around the crack. After it dried it looked like a dark
gray concrete, and it seemed to get harder after running the engine and
heating it up via the manifold heat.
--DAvid C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|