Hello spridgets
i had asked earlier as to the NUT size on the tappet adjustment.
7/16 seems to be the consensus.
my question now becomes is this a 1/4-28 bolt? .. if so i have
done the math for how many "clicks" to achieve a certain
clearance. this (in my case .018 HOT) means that 14 clicks will give
me .0173, or 15 clicks will give me .0186. most advice that i
have received indicates that tighter is better than looser, ergo
14 clicks should be it?... if this is NOT a 28 thread bolt,
someone PLEASE tell me what it is?
--
Best regards,
Bill mailto:pythias@pacifier.com
'66 Sprite
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|