In a message dated 5/21/02 10:41:47 PM Eastern Daylight Time,
pixelsmith@gerardsgarage.com writes:
> I was thinking of trying that, but don't they need to be hardened?
>
I wouldn't think the locating pins would have to be hardened since they only
locate the flywheel onto the crank and take little or no pressure. The
hardened flywheel bolts, tightened to proper torque take the pressure.
--David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|