Well I'm confused again/still. The brake lights were on all the time so I
replaced the switch and before I put the new switch in I put an ohm meter
across the poles and it read as an open, ok that's good, but when I screwed it
down I now have a short across the poles and the brake lights are on again.
What gives ? Am I doing something wrong ?
Dave
60 Bugeye
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|